Analysis of crack tip plasticity for microstructurally small cracks using crystal plasticity theory

Crack tip plastic zone sizes and crack tip opening displacements (CTOD) for stationary microstructurally small cracks are calculated using the finite element method. To simulate the plastic deformation occurring at the crack tip, a two-dimensional small strain constitutive relationship from single crystal plasticity theory is implemented in the finite element code ANSYS as a user-defined plasticity subroutine. Small cracks are modeled in both single grains and multiple grains, and different crystallographic conditions are considered. The computed plastic zone sizes and CTOD are compared with those found using conventional isotropic plasticity theory, and significant differences are observed.     

四种国民常用饮水中非挥发性有机物及其致突变活性的比较研究

比较我国居民常用饮水种类自来水、净化水(自来水经净水器过滤)、凉开水(自来水经煮沸后冷却)、纯净水(自来水经以反渗透为主的多重工艺处理)的非挥发性有机物(NOP)污染状况及其致突变活性。结果表明,四种水中检测到的NOP种类分别为自来水39种,净化水40种,凉开水20种,纯净水8种;毛细色谱显示的NOP总丰面积值依次为5.62×109,5.57×109,2.65×109,1.87×109。四种水的移码型及碱基置换型致突变活性依次为:自来水>净化水>凉开水>纯净水,其中自来水在相当1L、2L、4L水量的剂量均为阳性致突变活性,而纯净水在同样的剂量均为阴性。     

表外储油层酸化防膨剂的评价及效果分析

本文论述了采用不同防膨试验方法评价不同类型粘土防膨剂,并以回归曲线和价值工程分析防膨效果。由分子结构理论提出分子保护膜的防膨机理新观点,论述了酸液中添加具有多种功能的非离子型防膨剂QC—1可提高表外储层酸化与排酸效果。     

用屏蔽暂堵技术封堵水平井裂缝性漏层

克拉玛依油田HW702水平井的大斜度段和水平段,将穿越纵向裂缝发育的二叠系佳木河组储层。为安全钻进和保护油层,用超细碳酸钙和磺化沥青复配后加入复合离子钻井液中成屏蔽暂堵的堵漏钻井液。室内用岩心试验,屏蔽暂堵后渗透率可降为0,暂堵深度小于3cm,可用酸化和射孔解堵。现场使用效果也很好,使HW702水平井顺利完钻,并获得工业油气流。     

横波速度各向异性初步探讨：—多波勘探资料的应用

在纵波、SH 型横波资料处理和解释过程中,我们发现四川 HBC 地区地下介质普遍存在方向各向异性。当横波通过方向各向异性介质时,分裂成两个波:一个波的偏振方向与裂缝平行,叫快横波;另一个波的偏振方向与裂缝走向垂直,叫慢横波。采用相应的观测和处理方法,便可获得快横波和慢横波剖面。根据同一界面的快、慢横波的旅行时可以求得各向异性系数。同样,还可以利用 SH 波与转换波的速度比求取各向异性系数。各向异性系数的大小,反映了裂缝的发育程度。如果野外作了 X、Y 分量观测,室内又作了坐标旋转处理,那么,就可以进一步确定裂缝带的方向。如果未作上述工作,也可以根据构造线走向,大致确定裂缝带的发育方向。     

Mannitol and oligosaccharides as new criteria for determining cold tolerance in sugarcane varieties

Sugarcane can be very susceptible to damage by freezes. Freeze-deteriorated cane can cause problems in processing and sometimes leads to a factory shut-down. This study was undertaken during the 2000/2001 harvest season to assess the cold tolerance performance of six commercial sugarcane varieties and to establish new and more sensitive criteria to measure cold tolerance. Two varieties CP 70-321 and CP 79-318, with known cold tolerance, were planted in the study as controls. The other varieties included LHo 83-153, LCP 85-384, HoCP 85-845 and HoCP 91-555. Freezing temperatures occurred on 20 December 2000 when the min. field temperature was −4.4 °C, and again on 21 December, 30 December through 5 January 2001, 9–10 January and 20–21 January. The lowest field temperature recorded was −5.6 °C on 4 January. Freezing conditions prevailed for 8–15 h during each freeze incident. Stalks of all varieties were frozen to the ground following the initial freeze, with freeze cracks evident only after the 4 January freeze. For this study, samples were taken on the date of the first freeze, 20 December, and subsequently again at 7, 14, 22 and 30 days after the first freeze. Criteria used to measure overall stalk cold-tolerance included changes in pH, Brix, dextran (ASI-II method), sucrose, glucose, and fructose concentrations. Mannitol, ethanol and the oligosaccharides, palatinose, leucrose, iso-maltotriose and 1-kestose, were simultaneuously measured using IC-IPAD. Marked differences were observed in most criteria for all varieties, particularly 22 and 30 days after the first freeze. Mannitol was strongly correlated (r²=0.84) with dextran, confirming its use as an indicator for cane dextran deterioration. In comparison, ethanol was only weakly correlated (r²=0.55) with dextran and did not always predict cane dextran deterioration. Iso maltotriose was the most sensitive oligosaccharide indicator of freeze deterioration, although both leucrose and palatinose could be used to confirm whether severe dextran formation (>1500 ppm/Brix) has occurred in cane. Isomaltotriose was strongly correlated (r²=0.89) with dextran and pH (r²=−0.83); pH was also a strong indicator of both dextran (r²=−0.85) and mannitol (r²=−0.92) formation. Four of the varieties, CP 79-318, LCP 85-384, HoCP 85-845 and HoCP 91-555, were shown to be susceptible to other sources of microbial and enzymic deterioration as well as dextran deterioration from Leuconostoc bacteria, especially 30 days after the first freeze. This was indicated by increased glucose/fructose ratios, ethanol formation, changes in 1-kestose concentration, and further sucrose losses.     

塔巴庙区块气层录井参数分析研究

塔巴庙区块气藏属于低压、低渗气藏,储集层物性差异大、含气级别高,但含气非均质性强,录井解释评价困难。针对这一问题,开展了综合判断储集层物性和含气性方面的研究,分别探讨了钻时与全烃、钻井液性能与全烃、钻井液粘度与全烃、气测显示与测井参数和烃组分与气显示之间的关系,分析了其相关性及其在塔巴庙区块气层解释评价中的意义及作用。通过相关性研究,不但摸索出定性解释评价气层的方法,同时为今后深入研究录井相关参数关系,探索其内在规律,为实现准确解释评价储集层奠定了基础。     

Q195冷轧板材轧制困难原因分析

针对部分Q195冷轧板材存在轧制困难的现象，进行了现场检验与分析。带状组织、混晶现象严重导致变形强化系数偏高是造成轧制困难的主要原因。     

Visualization and quantification of the mechanical deformation induced by an electrical field in poly(ethylene naphthalene 2,6‐dicarboxylate) (PEN) films

An optical nondestructive strain measurement technique was performed to analyze the mechanical deformation induced by an electrical field within the insulating materials. Poly(ethylene naphthalene 2,6‐dicarboxylate) (PEN) films were then subjected to constant electrical fields right up to their electrical breakdown. The experimental technique made it possible to follow the various stages of the mechanical behavior of PEN in real time. The final breakdown occurred in the observation zone and the related mechanical deformation was captured. A “margarita” structure was observed with a hole at the center. The experimental results indicated that the level of the induced‐mechanical deformations depended on the local environment. We defined two different zones representing the inside and the outside of the damaged area. The induced‐deformations were larger in the damaged zone. It was also observed that deformations increased when the sample had a lower degree of crystallinity. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Antimicrobial finishing of regular and modified polyethylene terephthalate fabrics

An effective two-stage method has been developed for imparting antimicrobial properties to regular polyethylene terephthalate (R-PET), polyethylene glycol modified polyethylene terephthalate (PEG-M-PET), R-PET/Cotton blend (R-PET/C) and PEG-M-PET/Cotton blend (PEG-M-PET/C) fabrics. The method consists of partial hydrolysis of the fabrics to create carboxylic groups in PET macromolecules followed by subsequent reaction with dimethylalkylbenzyl ammonium chloride (DMABAC) under alkaline conditions. The reaction conditions such as pH, reaction temperature and time, carboxylic content, and DMABAC concentration were studied. Characterization of the finished fabrics was carried out through scanning electron microscopy (SEM) and Fourier transform infrared spectra (FTIR). All the modified PET fabrics showed excellent antibacterial activity towards Gram-positive (Bacillus mycoides), Gram-negative (Escherichia coli), and nonfilamentous fungus (Candida albicans). The achieved antimicrobial functions on the PET fabrics are durable in repeated laundering processes. Even after laundering 10 times the fabrics could still provide more than 85% of its antimicrobial activity against B. mycoides, E. coli, and C. albicans. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008